My 88 Trans Am GTA

just playing with camera settings etc

I see

Getting the GTA ready to go to the bodyshop

did you cry

No lol as wont be long before the graphics will be back on

GTA is all done so pick it up Monday morning

That was quick looking good

Just need to take the other stickers off now lol

that was very quick looks nice did he take the screen out to do the pillar

Cheers guys

New stickers being sorted tomorrow when I pick the car up hopefully

No screen left in when he did the pillar which was good as did not really want to take it out.

Very nice D B

I have some poc stickers for you

its ok kev, keep them for yours
they like 2nd gens there

How hardnwas your headers to fit ? Look like a pita to me ?

Might farm kt out !!

Not too bad, a bit of a pain but can do them in a day.

Have any bother with the studs ?

no, all undid ok
you need to undo an engine mounting and jack up engine an inch or two, and a bit of messing around but do-able

How about acess near the blower ac bit looks tight.

lot of tight spots just needs a good selection of sockets and extensions etc.
note, that they will probably be 3/8 AF, not metric
you can buy header bolts with torx or allen drive that would make life easier than with the bolts supplied with headers. I would get a set if doing again

Top tip. I read that somewhere else too.it looks a pita

Bit more done today, started rubbing down the rear spoiler ready to be sprayed tomorrow and also washed and cleaned it out and loaded the stuff in ready for Sunday.

Plus put the first of the stickers back on

looking good

I bought some Allen header bolts at the nats show £4 ! Cheap

And a burger ...... Lol

thirdgen wrote:I bought some Allen header bolts at the nats show  £4 !  Cheap

And a burger ...... Lol

are you sure it was only one